Talkaphone VOIP-500K Native VoIP Keypad Emergency Phone - Manual (Page 17)

VOIP-500 Series Phone
Configuration and Operation Manual
Page 17 of 90
Copyright 2012 Talk-A-Phone Co. • 7530 North Natchez Avenue • Niles, Illinois 60714 • Phone 773.539.1100 • [email protected] • www.talkaphone.com.
All prices and specifications are subject to change without notice. Talk-A-Phone, Scream Alert, WEBS and WEBS Contact are registered trademarks of Talk-A-Phone Co. All rights reserved.
4.4.2. SIP Settings
This page is used to configure the phone number, SIP registrars and outbound proxy details.
Login → Network → SIP Settings
Figure 6 SIP Settings
To configure SIP settings:
1. Enter the Phone Number (number used to call from other SIP endpoints).
2. Enter the Fully Qualified Domain Name or the IP Address of the SIP Gateway/Proxy. Secondary and
Tertiary FQDN or IP Addresses can be assigned for failover. There is a 30 character limit for this field. The
voip500.local is the default placeholder.
3. Check or Uncheck Register to enable or disable the SIP registration.
4. Enter SIP registrar details: (Secondary and Tertiary details can be assigned for failover)

Username: This is an optional field however it is required when Authentication is enabled on the SIP
registrar. Valid entries include alphanumeric and special
characters (underscore “_” and period “.”)

Password: This is an optional field however it is required when Authentication is enabled on the SIP
registrar. Valid entries include alphanumeric and special characters (except “&”).

IP Address and Port: Configure the IP Address and Port of the SIP registrar on which you want to
register the phone. Valid port range is 1024-49151.

Re-registration Time: Configure the registration refresh time. On expiration of this time interval, the
phone automatically sends a new register request to the registrar. Default re-registration time is
3600 seconds. Valid range is 10-14400 seconds.
1
3
4
6
4
2
5