Talkaphone VOIP-500K Native VoIP Keypad Emergency Phone - Manual (Page 62)

VOIP-500 Series Phone
Configuration and Operation Manual
Page 62 of 90
Copyright 2012 Talk-A-Phone Co. • 7530 North Natchez Avenue • Niles, Illinois 60714 • Phone 773.539.1100 • [email protected] • www.talkaphone.com.
All prices and specifications are subject to change without notice. Talk-A-Phone, Scream Alert, WEBS and WEBS Contact are registered trademarks of Talk-A-Phone Co. All rights reserved.
Operation Key Code Function
DTMF
Authentication
Code Required
(if configured)
takes effect for the current
call only.
AUX Output
Activation/Deac-
tivation
*11*  Aux 1 Activation
*12*  Aux 2 Activation
*13*  Aux 3 Activation
*21*  Aux 1 Deactivation
*22*  Aux 2 Deactivation
*23*  Aux 3 Deactivation
These are the default codes
and can be changed from
Web GUI.
Code is used for
activation/deactivation of
the Auxiliary Output by the
remote side phone during
the conversation. Yes
Voice Message
Recording
*91*<Message Number>*
Message Number : 0-5
Note: Voice message
programmed for Message
Number 0 is used for the
“Key Press to Answer”
feature.
Code is used for recording
the message after the
beep. Pressing a key stops
the recording. Yes
Voice message
previewing
*92*<Message num>*
Message num : 0-5
Voice message
programmed for Message
Number 0 is used for the
“Key Press to Answer”
feature.
Code is used for previewing
a recorded voice message.
Pressing a key stops the
previewing. Yes
“Help on the Way”
LED Activation
*98*  Enable
*97*  Disable
These are the default codes
and can be changed from
the Web GUI.
Code is used to
enable/disable the “Help on
the Way” LED. Yes
Call Termination
#  To disconnect current
call
This is the default code and
can be changed from the
Web GUI.
Single digit key code to be
used to disconnect the call. No