Talkaphone VOIP-500K Native VoIP Keypad Emergency Phone - Manual (Page 52)

VOIP-500 Series Phone
Configuration and Operation Manual
Page 52 of 90
Copyright 2012 Talk-A-Phone Co. • 7530 North Natchez Avenue • Niles, Illinois 60714 • Phone 773.539.1100 • [email protected] • www.talkaphone.com.
All prices and specifications are subject to change without notice. Talk-A-Phone, Scream Alert, WEBS and WEBS Contact are registered trademarks of Talk-A-Phone Co. All rights reserved.

Firmware upgrade initiated. Do not reboot...: The firmware upgrade has been initiated; the
firmware upgrade request is processed only when phone is in an idle state. For example, a call is in
progress and administrator requests for a firmware upgrade through the Web GUI. The phone checks
for an active call every five seconds and starts the process once the active call is terminated.
The following are considered to be idle phone states: no active call, no dialing, no voice message is
being played, and the Auxiliary Output is deactivated.

Firmware upgrade in progress. Do not reboot...: The firmware upgrade is in progress. The process
generally takes around 1-2 min to complete.

Firmware upgrade done. Going to reboot...: The firmware upgrade is complete and a reboot has
been initiated. After approximately one minute, the phone will be accessible once again.
4.10.7. SMTP Server Configuration
The SMTP Server Configuration page is used to configure the mail settings for email notifications.
Login → Maintenance → SMTP Server Configuration
Figure 29 SMTP Server Configuration
To setup SMTP:
1. Check the Enable SMTP check box.
2. Enter the SMTP Address and Port where emails should be sent.
3. Click Apply to save settings.
3
1
2