Voip-500, Series phone configuration and operation manual – Talkaphone VOIP-500K Native VoIP Keypad Emergency Phone User Manual
Page 61
VOIP-500
Series Phone
Configuration and Operation Manual
Page 61 of 90
Copyright 2012 Talk-A-Phone Co.
• 7530 North Natchez Avenue • Niles, Illinois 60714 • Phone 773.539.1100 • [email protected] • www.talkaphone.com.
All prices and specifications are subject to change without notice. Talk-A-Phone, Scream Alert, WEBS and WEBS Contact are registered trademarks of Talk-A-Phone Co. All rights reserved.
Appendix A: Remote Operation Key Codes
– Quick Reference
During a call, the following operations can be performed on the phone by dialing a key code sequence from
the remote side phone which supports the sending of DTMF
21
. If configured, these operations may require
DTMF authentication codes (Refer to 4.8 Authentication: DTMF Authentication Code).
Here is an example of how to use the DTMF operation codes during an active call.
For example, to adjust the volume of speaker from a remote phone, follow these steps:
Authenticate using key sequence *4*<authentication code>*. Successful authentication is indicated by a
single beep. This step is required only when DTMF authentication is enabled for volume adjustments (Refer
to 4.8 Authentication: enable/disable the DTMF authentication)
Dial the key sequence *31*8*. This sets the volume level of the speaker to 8. Successful operation is
indicated by a single beep.
Note The DTMF Authentication Code is only required once during a call and is valid until the call is
terminated.
Operation
Key Code
Function
DTMF
Authentication
Code Required
(if configured)
Enter Configuration
Mode
*4*<authentication code>*
Code is used to control
access to the device.
Microphone Gain
Adjustment
*31*<Level>*
Valid Level range : 1-20
Code is used to control
microphone gain levels.
This applies to both
handset and hands-free
models. The code takes
effect for the current call
only.
Yes
Speaker Gain
Adjustment
*32*<Level>*
Valid Level range : 1-20
Code is used to control
speaker gain levels. This
applies to both handset and
hands-free models. The
code takes effect for the
current call only.
Yes
Speaker
Enable/Disable
*5* Enable Speaker
*6* Disable Speaker
Code is used to
enable/disable the speaker.
This applies to both
handset and hands-free
models. The code takes
effect for the current call
only.
Yes
Microphone
Enable/Disable
*7* Enable Microphone
*8* Disable Microphone
Code is used to
enable/disable the
microphone. This applies to
both handset and hands-
free models. The code
Yes
21
Out-of-band RTP