Voip-500, Series phone configuration and operation manual, Authentication – Talkaphone VOIP-500K Native VoIP Keypad Emergency Phone User Manual
Page 42
VOIP-500
Series Phone
Configuration and Operation Manual
Page 42 of 90
Copyright 2012 Talk-A-Phone Co.
• 7530 North Natchez Avenue • Niles, Illinois 60714 • Phone 773.539.1100 • [email protected] • www.talkaphone.com.
All prices and specifications are subject to change without notice. Talk-A-Phone, Scream Alert, WEBS and WEBS Contact are registered trademarks of Talk-A-Phone Co. All rights reserved.
4.9. Authentication
The Authentication page allows the administrator to change the user credentials used to access the phone
through the Web interface, set the guard access code, and enable/disable the DTMF authentication
requirement for specific DTMF operation codes.
Login → Authentication
Figure 22 Authentication
To configure the authentication details:
1.
Enter the user credentials to access the Web interface:
Username
15
accepts alphanumeric
and special characters (e.g., underscore “_” and period “.”).
Password
16
accepts alphanumeric values and special characters (except “&”).Configure the Key
Code sequence to be used by the Local User for deactivation of the corresponding Auxiliary Output.
Confirm password requires you to type the password again for reconfirmation.
2.
Enter the Guard Access Code. It is used for authentication when the remote side phone supports the
sending of DTMF. The length of the Guard Access Code can be up to eight characters.
15
The maximum number of characters in username is 30.
16
The maximum number of characters in password is 30.
1
2
6
4
3
4
5