Voip-500, Series phone configuration and operation manual – Talkaphone VOIP-500K Native VoIP Keypad Emergency Phone User Manual
Page 9
VOIP-500
Series Phone
Configuration and Operation Manual
Page 9 of 90
Copyright 2012 Talk-A-Phone Co.
• 7530 North Natchez Avenue • Niles, Illinois 60714 • Phone 773.539.1100 • [email protected] • www.talkaphone.com.
All prices and specifications are subject to change without notice. Talk-A-Phone, Scream Alert, WEBS and WEBS Contact are registered trademarks of Talk-A-Phone Co. All rights reserved.
3. Getting Started
3.1. Pre-requisites
Prior to configuring a VOIP-500 Series Phone, ensure the unit is powered on and connected to the network.
The VOIP-500 can be configured from a computer with either a TCP/IP network connection or a DB-9 Serial
port. The VOIP-500 supports straight-through serial connections for basic programming. For access to the full
configurable feature set, a modern web browser will be required.
The VOIP-500 currently supports access from:
Internet Explorer 8 or greater
Firefox 3.5 or greater
3.2. Configuration Using the Web GUI
1.
Ensure both the VOIP-500 and your PC are connected to the Local Area Network. A direct connection to
the VOIP-500 will require the use of a crossover network cable.
VOIP-500 Series Phones are pre-configured with the following default settings:
IP Address:
192.168.1.10
Username:
admin
Password:
admin@123
2.
Configure the IP address of your PC to be on the same subnet as the VOIP-500. For example, 192.168.1.3
3.
Open a supported web browser and direct it to the IP address of the VOIP-500. For example, enter the
following URL:
The browser prompts for authentication:
Figure 1 Authentication Required
4.
Enter the default Username and Password. After authentication is successful, you are redirected to the
Home page.
5.
Further configuration of VOIP-500 settings are examined in Section 4: Using the Web GUI.