Talkaphone VOIP-500K Native VoIP Keypad Emergency Phone - Manual (Page 41)

VOIP-500 Series Phone
Configuration and Operation Manual
Page 41 of 90
Copyright 2012 Talk-A-Phone Co. • 7530 North Natchez Avenue • Niles, Illinois 60714 • Phone 773.539.1100 • [email protected] • www.talkaphone.com.
All prices and specifications are subject to change without notice. Talk-A-Phone, Scream Alert, WEBS and WEBS Contact are registered trademarks of Talk-A-Phone Co. All rights reserved.
4.8.2. Played to Remote Side
Note Not all VoIP topologies support this feature. Contact Talk-A-Phone for further information.
This configuration page allows the administrator to configure the voice message that needs to be played to
the remote side.
Login → Voice messages → Played to Remote Side
Figure 21 Voice Messages Played to Remote Side
To configure the voice messages played to remote side:
1. Use the drop-down menu to select the voice message to be configured.
2. The voice message is played to the remote side on selection of one of the following events:
i. Select Guard Answers Call to play the voice message to remote side when the remote phone
answers the call.
ii. Select and enter the Key Code sequence entered by remote side to play the voice message to the
remote side when the corresponding key sequence is entered by the remote side during an active
call.
3. Select Looping – Yes/No to loop the voice message until the “stop message” event occurs.
4. The selected voice message stops playing on selection of the following events:
i. Select and enter the Key code sequence entered by Remote Side to stop playing the voice
message to remote side when the corresponding key sequence is entered by the remote side during
an active call.
5. Click Apply to save settings.
Note You cannot use the same event to activate and deactivate the same voice message.
1
2
5
4
3
4