Canon 3170 Series - Manual (Page 11)

x Preface
LASER CLASS 3170 Series.
CFYA/YAH/YAN 120v US V1.0
Users in Canada
PRE-INSTALLATION REQUIREMENTS FOR CANON
FACSIMILE EQUIPMENT
A. Location
Supply a suitable table, cabinet, or desk. See Appendix A: Specifica-
tions for details about unit's weight and dimensions.
B. Order Information
1. Provide only a single line or touch-tone or rotary telephone set
terminated with a standard 4-pin modular phone plug. (Touch-
tone is recommended if available in your area.)
2. Order an RJ11-C modular wall jack (USOC code), which should
be installed by the phone company. If the RJ11-C wall jack is not
present, telephone/fax operation is not possible.
3. Order a normal business line from your telephone company’s
business representative. The line should be a regular voice grade
line or the equivalent. Use one line per unit.
DDD (Direct Distance Dial) line
-if not-
IDDD (International Direct Distance dial) line if you communi-
cate overseas
Canon recommends an individual line following industry standards
such as the 2500 (touch tone) or 500 (rotary/pulse dial) telephones. A
dedicated extension off a PBX without Camp On signals is also permitted
with a fax unit. Key telephone systems are not recommended because
they send non-standard signals to individual telephones for ringing, or
send special codes which may cause a fax error.
C. Power Requirements
The power outlet should be a three-prong grounded receptacle (single
or duplex). It should be independent from copiers, heaters, air condi-
tioners or any electrical equipment that is thermostatically controlled.
The rated value is 120 volts and 15 amperes. The RJ11-C modular jack
should be relatively close to the power outlet to facilitate installation.