Canon 3170 Series - Manual (Page 145)

4-30 Setting Up and Using Speed Dialing Chapter 4
LASER CLASS 3170 Series.
CFYA/YAH/YAN 120v US V1.0
Here are some important points you should keep in mind when
you use One-touch Speed Dialing:
❏
To start scanning immediately, press Start/Scan . Otherwise the
fax will wait 5 seconds before it starts scanning. This timeout
feature can be turned off. (
➞16-11)
❏
To locate and press the correct button, you may have to open
the One-touch Speed Dialing panels.
❏
The fax will not dial the number registered for the One-touch
Speed Dialing button until you set the document on the fax
for sending. If you press the button before you load the
document, the fax will prompt you:
SET DOCUMENT
❏
If you press a One-touch Speed Dialing button where no
number has been registered, the fax tells you:
NO TEL#
12
❏
If you want to cancel the transmission after you press a One-
touch Speed Dialing button, press
Stop . ( ➞6-8)
❏
When you come to a step in any procedure where you have to
dial a number, you can press a One-touch Speed Dialing
button to dial.
When you register a number for One-touch Speed Dialing, Coded Speed
Dialing and Group Dialing, you can, as an option, set the time you want
your document to go out (up to 5 different times in a day). If you are
using a speed dial button that was set by someone else, and you would
like your document to go out at the preset time, verify if the preset time
feature is being used for that button. (
➞4-9, 4-18, 4-27, 16-34)