Canon 3170 Series - Manual (Page 149)

4-34 Setting Up and Using Speed Dialing Chapter 4
LASER CLASS 3170 Series.
CFYA/YAH/YAN 120v US V1.0
Here are some important points you should keep in mind when
you use Group Dialing:
❏
To start scanning immediately, press Start/Scan . Otherwise the
fax will wait 5 seconds before it starts scanning. This timeout
feature can be turned off. (
➞16-11)
❏
The fax will not dial the numbers for the Group Dialing
number until you set the document on the fax. If you press the
One-touch Speed Dialing button or press
Coded Dial followed
by a three-digit code, before you load the document, the fax
will prompt you:
SET DOCUMENT
❏
If you press a One-touch Speed Dialing button, or press Coded
Dial followed by a three-digit code, where no number has been
registered, the fax will display:
NO TEL#
12
If you want to cancel the transmission after you press a One-touch
or Coded Speed Dialing button, press
Stop .
When you register a number for One-touch Speed Dialing, Coded Speed
Dialing and Group Dialing, you can, as an option, set the time you want
your document to go out (up to 5 different times in a day). If you are
using a speed dial button that was set by someone else, and you would
like your document to go out at the preset time, verify if the preset time
feature is being used for that button. (
➞4-9, 4-18, 4-27, 16-34)