Canon 3170 Series - Manual (Page 147)

4-32 Setting Up and Using Speed Dialing Chapter 4
LASER CLASS 3170 Series.
CFYA/YAH/YAN 120v US V1.0
Here are some important points you should keep in mind when
you use Coded Speed Dialing:
❏
To start scanning immediately, press Start/Scan . Otherwise the
fax will wait 5 seconds before it starts scanning. This timeout
feature can be turned off. (
➞16-11)
❏
The fax will not dial the Coded Speed Dialing number until
you set the document on the fax for scanning. If you press the
buttons before you load the document, the fax will prompt
you:
SET DOCUMENT
❏
If you press Coded Dial and a three-digit code where no
numbers are registered, the fax tells you:
NO TEL #
* 013
❏
If you want to cancel the transmission after you press the
buttons for Coded Speed Dialing, press
Stop .
❏
When you come to a step in any procedure where you have to
dial a number, you can press the buttons for Coded Speed
Dialing to dial.
When you register a number for One-touch Speed Dialing, Coded Speed
Dialing and Group Dialing, you can, as an option, set the time you want
your document to go out (up to 5 different times in a day). If you are
using a speed dial button that was set by someone else, and you would
like your document to go out at the preset time, verify if the preset time
feature is being used for that button. (
➞4-9, 4-18, 4-27, 16-34)