Canon 3170 Series - Manual (Page 247)

9-12 Using a Relay Network Chapter 9
LASER CLASS 3170 Series.
CFYA/YAH/YAN 120v US V1.0
Sending a Document to a Relay Unit with Speed Dialing
You can register a telephone number for relay sending under a One-
touch or Coded Speed Dialing button.
Check these points before you send a document to another party for
relay:
❏
Contact the other party and ask for the ITU-T subaddress and
password they are using for receiving documents to relay.
❏
The other party’s fax unit does not have to be a Canon fax unit, but
make sure the other party’s fax unit supports the use of ITU-T
subaddresses and passwords.
❏
Perform the procedure to register a telephone number for One-touch
or Coded Speed Dialing. (
➞4-6, 4-15) If the speed dialing buttons are
already set up, perform the procedure to change the One-touch or
Coded Speed Dialing settings. (
➞4-6, 4-15)
❏
When you do the speed dialing settings, turn on the OPTIONAL
SETTING feature and select TX TYPE. Select ORIG RELAY TX and
then set the ITU-T subaddress and password. (
➞4-11, 4-21) Confirm
that the other party is set up properly to relay documents received
from your fax. Your fax cannot confirm whether or not the other fax
has been set up properly for relaying a document sent from your fax.
Sending with the Relay Broadcast Button
Follow this procedure to send the original document for a relay broad-
cast with the
Relay Broadcast button.
You can set only one destination.
1. Set the document on the fax. ( ➞6-3)
Set the document resolution, contrast, and document type. (
➞6-4)
You can also select a sender’s name with the TTI Selector . (
➞6-6)