Toa M-864D Ver.2.2.0 - Manual (Page 101)

101
1. Preset Load
Sets whether to lock or unlock the Preset Memory
Load function.
If set to Lock, the Preset Memory cannot be
recalled using the unit’s front panel Preset
Memory key.
2. Preset Store
Sets whether to lock or unlock the Preset Memory
Storage function.
If set to Lock, the Preset Memory cannot be stored
using the unit’s front panel Preset Memory key.
3. Low CUt
Sets whether to lock or unlock the monaural input
low-cut filters.
If set to Lock, the low-cut filters cannot be switched
ON or OFF using the unit’s front panel Low-Cut
switch.
4. fBS
Sets whether to lock or unlock the monaural input
Feedback Suppression switch.
If set to Lock, the FBS dynamic mode cannot be
switched ON or OFF using the unit’s front panel
Feedback Suppression switch.
5. MoNo
Sets whether to lock or unlock the stereo input
Assign mode.
If set to Lock, the Assign mode cannot be switched
using the unit’s front panel Mono/Mix switch.
6. toNe
Sets whether to lock or unlock the monaural and
stereo input Tone/Gain selector switches.
If set to Lock, the Tone control settings cannot be
changed from the unit’s front panel.
7. GaIN, trIM
Sets whether to lock or unlock the Monaural Input
Gain switch and Stereo Input Trim switch.
If set to Lock, the monaural input gain settings
(Phantom Power, PAD, and Gain) and stereo input
trim settings (Trim, Gain) cannot be changed from
the unit’s front panel.
8. arC
Sets whether to lock or unlock the ARC switch.
If set to Lock, the ARC switch cannot be used for
operation.
9. reC oUt
Sets whether to lock or unlock the recording
output switch.
If set to Lock, operation of the unit’s front panel
REC OUT VOL. knob is disabled.
10. aSSIGN
Sets whether to lock or unlock the Assign switch.
If set to Lock, the unit’s front panel Assign switch
cannot be used to change assignment settings.
11. faDer
Sets whether to lock or unlock the FRONT fader.
If set to Lock, front fader operations are disabled
retaining the fader gain as it was at the time the
fader was locked.
Notes
• Front faders disabled in the Fader Settings (see
p. 99 ) are fixed at 0 dB gain, regardless of
their Locked or Unlocked status.
• To change the FRONT fader gain using the
FRONT fader, the Lock mode must be set to
“Unlock” and the fader enabled in the Fader
Settings (See p. 99 ).