Toa M-864D Ver.2.2.0 - Manual (Page 90)

90
[Preset Memory Load]
Calls up Preset Memory.
Set the Preset Memory (1 – 16) to be called up in the ”Preset No.” column of Parameter 1. If the ZM Remote
Controller’s button is pressed, the Preset Memory set in the “Preset Number” column is called up. If different
Preset Memories are assigned to multiple buttons, the last pressed button takes precedence.
[remote Switched out]
Controls the M-864D’s contact output terminals.
Set the control output terminal number (1 – 8) to be operated in the “Contact Out No.” column of Parameter 1.
Notes
• If the selected contact output terminal is not assigned the “Remote Switched Out” function, it will not operate.
The contact input terminal of the device to be controlled must also be set to the “Remote Contact Input”
function.
• The control method of the selected contact output terminal differs depending on its “Control” column settings.
Make: The terminal is closed when the button is pressed and opened when the button is released.
Pulse: A shorting pulse is generated between the corresponding terminal and the C terminal with each
depression of the button.
[remote Command]
Assign the command number for the External control command send function to the terminals.
Press the ZM Remote controller’s button to send the specified command.
[ext VoL. GainCS (Channel Select)] (function provided only with the ZM-9014)
Select the channel to be operated with the volume control knob.
Change the channel to be operated with the volume control knob by pressing the ZM Remote controller’s button.
Notes
• Assign the same function to the volume control knob.
• This function does not work even if allocated to the channel for which the EXT VOL. fader is disabled.
[Matrix Crosspoint GainCS (Crosspoint Select)] (function provided only with the ZM-9014)
Select the Matrix crosspoint to be operated with the volume control knob.
Change the Matrix crosspoint to be operated with the volume control knob by pressing the ZM Remote
controller’s button.
Note: Assign the same function to the volume control knob.
[when no functions are assigned to the button]
Select “None” with the Function button.