Toa M-864D Ver.2.2.0 - Manual (Page 66)

66
5. Detail Settings Panel
Individual Settings, Global Settings and
Measurement Settings can be performed through
tab selection.
(1) Individual Settings
Filter point No.
A. Frequency control
B. Gain control
C. Q control
D. ON/OFF button
E. Default button
a. frequency Control
Sets each filter point’s frequency.
The downward pointing triangle button
decreases the frequency and the upward
pointing triangle button increases the
frequency.
Clicking the frequency indication in the
center opens the dialog for frequency entry.
B. Gain Control
Sets each filter point’s gain.
The downward pointing triangle button
reduces the gain and the upward pointing
triangle increases the gain. Clicking the gain
indication in the center opens the dialog for
gain entry.
C. Q Control
Sets each filter point’s Q.
The downward pointing triangle button
reduces Q and the upward pointing triangle
button increases Q.
Clicking the Q indication in the center opens
the dialog for Q selection.
D. oN/off Button
Used to set each filter point to ON or OFF.
ON: Filter is enabled (orange display).
OFF: Filter is disabled (blue display).
The filter is bypassed if set to OFF.
(2) Global Settings
A. Global gain control
B. All On/Off button
C. All Default button
a. Global Gain Control
Used to finely adjust the strength of
automatically created filters.
To increase the filter strength, click the
lower [Aggressive] button, and the upper
[Moderate] button to moderate it. To return
the filter to standard strength, click the
[Normal] button in the center. The strength
can also be finely adjusted with the use of a
slider at right.
B. all on/off Button
Selects ON or OFF for all 12 filters.
ON: Filter is enabled. (orange display)
OFF: Filter is disabled. (blue display)
The filter is bypassed if set to OFF.
C. all Default Button
Returns all 12 filters to the parameters
created by ARC measurement.
tips
• The ARC box retains the following 2
different settings: filter data created by
ARC measurement and actual operation
filter data manually adjusted. The former
data can be initialized by the Initialize
button shown on the next page .
• On the graph display, the filter data created
at measurement is indicated by a dotted
line and the actual operation filter data is
indicated by a solid line.