Toa M-864D Ver.2.2.0 - Manual (Page 25)

25
[fader]
Displays individual gain values of the FRONT fader (fader on the unit’s front panel), PC VOL. (setting software
fader) and EXT VOL. (external control of the ZM Remote controller, etc.), as well as their total gain value.
When grouping has been set, the corresponding group number is displayed.
Each gain is also indicated by a bar extending from the left.
Note: Gains for both L and R stereo channels are interlocked.
Faders set to “Disable” in the fader settings (see p. 99 ) are not displayed.
The FRONT fader gain is displayed only while in online mode.
When in offline mode, the total gain is obtained as 0 dB of the FRONT fader gain.
Note: Faders set to “Disable” are fixed at 0 dB gain.
For fader settings, see p. 49 , “Function Box.”
[tone]
Roughly displays the frequency characteristic curve set with the tone control.
Frequency characteristics are indicated by a flat straight line when BASS, MID and TREBLE gains are all set
to 0 dB.
Note: Tone control settings for both L and R stereo channels are interlocked.
For tone settings, see p. 52 , “Function Box.”
[auto-Mute]
Displays the Auto-Mute ON/OFF status for output channels 1 – 4.
Orange indicates ON and gray indicates OFF.
(In the figure below, outputs 1 and 2 are ON, and outputs 3 and 4 are OFF.)
Note: ON/OFF settings here have nothing to do with output assignment.
Use the matrix function boxes for output signal assignment (see p. 59 ).
Note: Auto-Mute ON/OFF settings for both L and R stereo channels are interlocked.
For Auto-Mute ON/OFF settings, see p. 57 , “Function Box.”
Group number