Toa M-864D Ver.2.2.0 - Manual (Page 9)

9
3. Connect
Units are automatically detected and the Unit’s IP Setting dialog is displayed.
Units that are available and not available for communications are displayed in the “Connectable units” and
“Unconnectable units” lists. If no units from which to receive data are shown, click the [Add] button to display
more units. Selecting this button causes the “Add target unit” dialog to be displayed (see the Add target unit
dialog below).
Select the unit from which to receive data from the “Connectable units,” then click the [Next] button to display
the Firmware version check screen.
If the displayed firmware version is old, update the firmware. (See, p. 78 , Step 6 in the “Connection
Settings.”
After selecting the unit from which to receive data, click the [Finish] button, and data reception begins,
displaying the communication dialog.
After data reception is completed, clicking the [Completed] button of the Communication Dialog switches the
display to the Main screen (see p. 11 ).
Note: The following logon screen may appear when the file opens:
When this screen appears, the User Level has been set.
Please read the section “Logging on with user level enabled” on p. 114 .
• Add target unit Dialog
Used to add target units.
Enter the IP address of the unit to be connected.