Pilz PSSnet SHL 8T MRP - Manual (Page 27)

Basic Settings
PSSnet SHL - Web- based Interface
Pilz GmbH & Co. KG, Felix- Wankel Str. 2, 73760 Ostfildern
1.4 Port configuration
27
Note: If you have set up VLANs, pay attention to the “Transparent mode”
(see on page 86 „VLAN Global“) .
Note: The active automatic configuration has priority over the manual
configuration.
Note: The following settings are required for the ring ports in a HIPER-Ring:
When you switch the DIP switch for the ring ports, the device sets the re-
quired settings for the ring ports in the configuration table. The port, which
has been switched from a ring port to a normal port, is given the settings
Autonegotiation (automatic configuration) on and Port on. The settings
remain changeable for all ports.
Figure 11: Port Configuration Table dialog
Bit rate 100 Mbit/s 1000 Mbit/s
Autonegotiation
(automatic configuration) Off On
Port On On
Duplex Full –
Table 2: Port settings for ring ports