Pengo TruLink - Manual (Page 26)

26 PENGO TruLink Manual
OPERATING PROCEDURES (4” DISPLAY)
SETTING INCLINOMETER:
To set the Inclinometer touch anywhere on the
bulls eye dial. 1
A new screen key pad will appear. Use the
arrow keys to set your desired angle resolution.
Resolutions available: 1, 2, 3 / 2, 4, 6 / 10, 20, 30 2
After the angle resolution has been set select
Center BullsEye, then OK. 3
If a pile (battered pile) is required to be installed
at an angle other then vertical, follow theses
steps:
4a) Move the pile into the desired angle with the prime
mover. The desired angle will be indicated on the display
in the Angle box.
4b) When the pile is at the desired angle touch anywhere
on the bullseye dial. The Selector screen will appear.
Select Center BullsEye and then OK.
This action will now keep the angle you selected as the
new center and allows you to monitor your new center
easily.
4c) To revert back to the default setting touch anywhere
on the bullseye dial. Ensure the Drive unit is hanging
vertically and select Center BullsEye then select OK.
4
Follow Step 4 only if the center of the bullseye needs
to be changed to something other then zero. Example,
installing piles at an angle. The bullseye can be
calibrated by touching the green dot on the bulls eye.
3a
2
4
1
3b