Pengo TruLink - Manual (Page 40)

40 PENGO TruLink Manual
JOB MANAGEMENT INPUT GUIDE (8” DISPLAY)
WARNING Before operating, always ensure that all electrical connections are tight and free from potential hazards
and or entanglement during operation.
Ensure Display unit has power. Power is
provided by the auxiliary port located inside
the prime mover operators cab. Chose a
convenient location to mount the TruLink
display. The location should not interfere with
safety devices (lap bar) or compromise the
operators visibility. The location should also
allow the operator to easily access the display to
start and stop the data recording function.
The display can be mounted to a glass surface
using the suction cup mount provided. When
using the suction cups be sure the surface is
clean to allow for maximum adhesion against
the glass.
The display can also be hard mounted to any
surface using hardware (not included). This
method is only recommended if the location is
to be permanent.
Select the “Menu” button to start the
new job process. The Job Management
screen will appear. 1
Select “Job Management” from the
menu. A new screen will appear as
shown to the right. 2
Select “New” from the Job Management
screen. This is where you will enter all
job related information for all new jobs. 3
NEW JOB SET-UP.
1
2
3