Pengo TruLink - Manual (Page 8)

8 PENGO TruLink Manual
1) 4.3” Touch Screen Display
CAN-based display module with a 4.3” TFT LCD touch
screen. Windows CE operating platform. Input power
supply range from 9 V to 32 V. Operating temperature
range of -20 C to +70 C. IP67 (ingress protection) allows
for outdoor use if required. USB port for data export.
2) TruLink Pin - Classes 1 and 2
Pin contains CPU, inclinometer and strain gages.
Class 1: 45mm diameter pin. 20,000 ft/lbs torque
capacity.
Class 2: 75mm diameter pin. 70,000 ft/lbs torque
capacity.
3) TruLink End Cap Kit - Class 1 and 2
End Cap Kit is comprised of the end cap, fastening bolt
and installation rod.
4) Display Power Harness (4.3” Display)
Wire harness provides power to the display via auxiliary
power coupler. Aux power coupler plugs into the auxiliary
(cigarette lighter) port. Wire harness also connects to
the main cable which links the TruLink pin to the display.
5) Cable Main 15’
Wire harness provides power to the display and CAN
logger via a auxiliary power coupler. Aux power coupler
plugs into the auxiliary (cigarette lighter) port. Wire
harness also connects the display and CAN logger to the
electrical cable running to the Anchor Drive wire harness.
6) Battery Back-Up Kit
Kit (harness and back-up box) provides power to the
Display. A Battery Back-Up Box is included with the
cable assembly. The Battery Back-Up Box is used to
turn the display on and off by use of the switch located
on the Battery Back-Up Box.
7) Cable Extension 15’
Cable is used to extend main cable in applications
8) 4.3” Display Mount
Mount is used to position the touch screen display within
the operators cab. Mount can be used with suction cups
(provided) or hard mounted using hardware (not provided).
9) Display Protective / Storage Case
Waterproof and impact resistant protective case. Used to
store the TruLink display when not in use.
10) Anti-Rotation Block Kit
Anti-Rotation block is used to position the TruLink pin in
the correct orientation plane. Kit is provided with several
types of hardware to outfi t all Pengo Revolution Series
Anchor Drives.
11) USB Flash Drive
2 GB fl ash drive provided for data export from TruLink
12) Stylus
Silicone tipped stylus, used as a section tool for the touch
screen display.
COMPONENT IDENTIFICATION (4” DISPLAY OPTION)
Parts list shown on this page are for the 4” Display option only.
Pengo continually looks for new ways to improve its products. Therefore, Pengo reserves the right to make changes to our
products and specifi cations without notice.