Kawai CN35 Owner’s Manual - Manual (Page 118)

118
Ap
pe
nd
ix
Assembly Instructions
4. Connecting the pedal and power cables
Pass the pedal cable (extending from the rear of the pedal
board) through the back board aperture to the front of the main
body, and connect to the PEDAL terminal.
Connect the AC/DC adaptore e to the DC IN terminal on the
underside of the main body, then pass the cable through the
back board aperture, and out to the rear of the instrument.
With the power and pedal cables connected, use the binders to
fix the cables in place and tidy their appearance.
5. Attaching the headphone hook k (optional)
A headphone hook is included with the CN35 digital piano and can
be used to hang headphones when not in use.
If desired, attach the headphone hook to the underside of the
main body using the two tapping screws provided.
* If the headphone hook will not be required, it can be kept with the
instruction manual.
6. Adjusting the pedal adjuster bolt
Turn the pedal support bolt anti-clockwise, extending the bolt
until it makes contact with the floor and supports the pedals
firmly.
When moving the instrument, always adjust or
remove the pedal support bolt, then readjust
when the instrument is in its new position.
Pedal support bolt