ATL Telecom OM100 - Manual (Page 30)

ATL USER GUIDE
OM100 Optical Multiplexer
57
Notes: a) The time and date are changed at the exact moment the <return> key is pressed.
b) Setting the “Inactive Time-Out”, should be done only after the time and date has
been set.
Description
Enter the new date in the format shown below.
dd/mm/yyyy.
Enter the new time in the format shown below.
hh:mm.
If the unit is left unattended the menus will automatically time-out.
The lower level menus will jump back one level. The top level menu will log
the user out. Pressing keys resets the time-out period.
Field
Date
Time
Inactive Time-Out
7
56 ATL USER GUIDE
OM100 Optical Multiplexer
7.2.4 Date and time set-up
OM100 Mon 01 Nov 2002 00:41:51
Configuration > System
Urgent Alarm:On Non-Urgent Alarm:Off
Date <01/11/2002>
Time (24Hr) <00:41>
Inactive Time-Out (min) <30>
Press Return to Accept or Escape to Cancel
F1 Help F3 Previous Menu F4 Main Menu
Configuration Master / Slave Master / slave configuration.
User Port Configure each E1 port – enable.
Protection Switching Configures the protection 1+1 switching.
System Set date, time and menu timeout.
Subsystem Names Enter name, description and location of this unit.
Monitoring Mode Configures monitoring mode.
Software Allows the downloading of software to the unit
and allows reset to factory default.
Serial Communications Local terminal set-up – baud rate, parity, handshake.
Reboot This option allows you to reboot the unit that you
are using, as well as its remote partner.
Front Panel Allows configuration of Front Panel controls.