ATL Telecom OM100 - Manual (Page 31)

7.2.6 Monitoring mode
Field Description
Report faults When logged off – prints alarms and faults as they occur
With warning bell Rings the bell each time a new fault is detected
OM100 Mon 01 Nov 2002 00:42:40
Configuration > Monitoring
Urgent Alarm:On Non-Urgent Alarm:Off
Monitoring Mode
Report Faults [ ]
With Warning Bell [ ]
Press Return to Accept or Escape to Cancel
F1 Help F3 Previous Menu F4 Main Menu
Configuration Master / Slave Master / slave configuration.
User Port Configure each E1 port – enable.
Protection Switching Configures the protection 1+1 switching.
System Set date, time and menu timeout.
Subsystem Names Enter name, description and location of this unit.
Monitoring Mode Configures monitoring mode.
Software Allows the downloading of software to the unit
and allows reset to factory default.
Serial Communications Local terminal set-up – baud rate, parity, handshake.
Reboot This option allows you to reboot the unit that you
are using, as well as its remote partner.
Front Panel Allows configuration of Front Panel controls.
7
ATL USER GUIDE
OM100 Optical Multiplexer
59 58 ATL USER GUIDE
OM100 Optical Multiplexer
7.2.5 Subsystem names
Field Description
Name 10 characters displayed on most menus - Used to identify the unit.
Description Text field. For information only.
Location Text field. For information only.
OM100 Mon 01 Nov 2002 00:42:19
Configuration > Subsystem Names
Urgent Alarm:On Non-Urgent Alarm:Off
Subsystem No: 1
Name <LT >
Description <Undefined >
Location <Undefined >
Press Return to Accept or Escape to Cancel
F1 Help F3 Previous Menu F4 Main Menu F7 Previous Subsystem
F8 Next Subsystem
Configuration Master / Slave Master / slave configuration.
User Port Configure each E1 port – enable.
Protection Switching Configures the protection 1+1 switching.
System Set date, time and menu timeout.
Subsystem Names Enter name, description and location of this unit.
Monitoring Mode Configures monitoring mode.
Software Allows the downloading of software to the unit
and allows reset to factory default.
Serial Communications Local terminal set-up – baud rate, parity, handshake.
Reboot This option allows you to reboot the unit that you
are using, as well as its remote partner.
Front Panel Allows configuration of Front Panel controls.