Configuration procedure – H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 105
96
AC's GigabitEthernet 1/0/1 belongs to VLAN 10. WLAN-ESS 1 is created on AC and configured as a
hybrid port with VLAN 10 as the default VLAN. Packets of VLAN 2, VLAN 3, and VLAN 10 are allowed
to pass WLAN-ESS 1.
The IPv6 multicast source sends IPv6 multicast data to IPv6 multicast group FF1E::101. Client A and Client
B belong to VLAN 2 and VLAN 3 respectively and they are receivers of the IPv6 multicast group.
Configure the port-based IPv6 multicast VLAN feature so that Router just sends IPv6 multicast data to AC
through the IPv6 multicast VLAN and AC forward the IPv6 multicast data to the receivers that belong to
different user VLANs.
Figure 24 Network diagram
Configuration procedure
1.
Enable IPv6 forwarding on each AC and configure the IPv6 address and address prefix for each
interface as per
. (Details not shown.)
2.
On Router, enable IPv6 multicast routing, enable IPv6 PIM-DM on each interface, and enable MLD
on the host-side interface Ethernet 1/2.
<Router> system-view
[Router] multicast ipv6 routing-enable
[Router] interface ethernet 1/1
[Router-Ethernet1/1] pim ipv6 dm
[Router-Ethernet1/1] quit
[Router] interface ethernet 1/2
[Router-Ethernet1/2] pim ipv6 dm
[Router-Ethernet1/2] mld enable
[Router-Ethernet1/2] quit
3.
Configure AC:
# Enable MLD snooping globally.
<AC> system-view
[AC] mld-snooping