Configuration procedure – H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 93
84
Figure 20 Network diagram
Configuration procedure
1.
Configure the IP address and subnet mask for each interface as per
. (Details not shown.)
2.
On Router, enable IP multicast routing, enable PIM-DM on each interface, and enable IGMP on the
AC-side interface Ethernet 1/2.
<Router> system-view
[Router] multicast routing-enable
[Router] interface ethernet 1/1
[Router-Ethernet1/1] pim dm
[Router-Ethernet1/1] quit
[Router] interface ethernet 1/2
[Router-Ethernet1/2] pim dm
[Router-Ethernet1/2] igmp enable
[Router-Ethernet1/2]quit
3.
Configure AC (for WX6103):
# On the configuration interface of the WX6103 AC main control board, enable IGMP snooping
globally.
<AC> system-view
[AC] igmp-snooping
[AC-igmp-snooping] quit
# Create VLAN 10, and enable IGMP snooping in this VLAN.
[AC] vlan 10
[AC-vlan10] igmp-snooping enable
[AC-vlan10] quit