H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 38
29
Total 1 MAC Group(s).
Port flags: D-Dynamic port, S-Static port, C-Copy port, P-PIM port
Subvlan flags: R-Real VLAN, C-Copy VLAN
Vlan(id):100.
Total 1 IP Group(s).
Total 1 IP Source(s).
Total 1 MAC Group(s).
Router port(s):total 0 port(s).
IP group(s):the following ip group(s) match to one mac group.
IP group address:224.1.1.1
(0.0.0.0, 224.1.1.1):
Attribute: Host Port
Host port(s):total 1 port(s).
WLAN-DBSS1:0 (D) ( 00:04:17 )
MAC group(s):
MAC group address:0100-5e01-0101
Host port(s):total 1 port(s).
WLAN-DBSS1:0
The output shows that WLAN-DBSS 1:0 on AC joins the multicast group 224.1.1.1.
Configuration procedure (for the WX6000 cards other than the WX6103)
1.
Configure WLAN services:
# Log into the configuration interface of a WX6000 card other than the WX6103 from the switch.
<Device> oap connect slot 2
Press CTRL+K to quit.
Connected to OAP!
User interface aux0 is available.
Press ENTER to get started.
<AC> system-view
# Configure WLAN-ESS interface 1 and assign it to VLAN 100.
[AC]Vlan 100
[AC-vlan100]quit
[AC]interface WLAN-ESS 1
[AC-WLAN-ESS1]port access vlan 100
[AC-WLAN-ESS1]quit
# Configure a WLAN service template with its SSID as multicast and authentication method as
open-system. Bind the WLAN-ESS interface with the service template.
[AC]wlan service-template 1 clear
[AC-wlan-st-1]ssid Multicast
[AC-wlan-st-1]bind WLAN-ESS 1
[AC-wlan-st-1]authentication-method open-system
[AC-wlan-st-1]service-template enable
[AC-wlan-st-1]quit
# Create AP template ap of model WA2100 and configure its serial ID as
210235A29G007C00001.
[AC]wlan ap ap model WA2100