H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 33
24
# Configure the client to access the WLAN service and request multicast traffic destined for
224.1.1.1.
4.
Verify the configuration:
# Display detailed IGMP snooping group information in VLAN 100 on AC after the client sends an
IGMP report for multicast group 224.1.1.1.
[AC]display igmp-snooping group vlan 100 verbose
Total 1 IP Group(s).
Total 1 IP Source(s).
Total 1 MAC Group(s).
Port flags: D-Dynamic port, S-Static port, C-Copy port
Subvlan flags: R-Real VLAN, C-Copy VLAN
Vlan(id):100.
Total 1 IP Group(s).
Total 1 IP Source(s).
Total 1 MAC Group(s).
Router port(s):total 1 port(s).
GigabitEthernet1/0/1 (D) ( 00:01:30 )
IP group(s):the following ip group(s) match to one mac group.
IP group address:224.1.1.1
(0.0.0.0, 224.1.1.1):
Attribute: Host Port
Host port(s):total 1 port(s).
WLAN-DBSS1:0 (D) ( 00:04:17 )
MAC group(s):
MAC group address:0100-5e01-0101
Host port(s):total 1 port(s).
WLAN-DBSS1:0
The output shows that WLAN-DBSS1:0 on AC joins the multicast group 224.1.1.1.
Configuration procedure (for the LSWM1WCM10 or LSWM1WCM20)
1.
Configure WLAN services:
# Log in to the configuration interface of the service card of AC from the switch.
<Device> oap connect slot 2
Press CTRL+K to quit.
Connected to OAP!
User interface aux0 is available.
Press ENTER to get started.
<AC> system-view
# Configure the WLAN-ESS interface and assign WLAN ESS 1 to VLAN 100.
[AC]Vlan 100
[AC-vlan100]quit
[AC]interface WLAN-ESS 1
[AC-WLAN-ESS1]port access vlan 100
[AC-WLAN-ESS1]quit