Configuration procedure (for the wx5004), Figure 13 – H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 69
60
Figure 13 Network diagram
Configuration procedure (for the WX5004)
1.
Enable IPv6 PIM-DM and MLD on the port of Router A that connects to AC, and enable IPv6
multicast routing globally.
2.
Configure WLAN services:
# Configure the WLAN-ESS interface and assign WLAN ESS 1 to VLAN 100.
<AC>system-view
[AC]Vlan 100
[AC-vlan100]quit
[AC]interface WLAN-ESS 1
[AC-WLAN-ESS1]port access vlan 100
[AC-WLAN-ESS1]quit
# Configure a WLAN service template with its SSID as multicast and authentication method as
open-system. Bind the WLAN-ESS interface with the service template.
[AC]wlan service-template 1 clear
[AC-wlan-st-1]ssid Multicast
[AC-wlan-st-1]bind WLAN-ESS 1
[AC-wlan-st-1]authentication-method open-system
[AC-wlan-st-1]service-template enable
[AC-wlan-st-1]quit
# Create AP template ap of model WA2100 and configure its serial ID as
210235A29G007C00001.
[AC]wlan ap ap model WA2100
[AC-wlan-ap-ap]serial-id 210235A29G007C00001
# Configure the type of radio 1 of the AP as 802.11g and map the service template to the current
radio.
[AC-wlan-ap-ap]radio 1 type dot11g
[AC-wlan-ap-ap-radio-1]service-template 1
[AC-wlan-ap-ap-radio-1]radio enable
[AC-wlan-ap-ap-radio-1]quit
[AC-wlan-ap-ap]quit
# Enable all radios.
[AC]wlan radio enable all
Router A
Source
AC
GE 1/0/1
GE 1/0/2
IPv6 Multicast Packets
AP
Client
Switch
WLAN-ESS1