H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 73)

64
Multicast delivery to a wireless client (for the WX6000 series)
Network requirements
As shown in Figure 14 , the source sends multicast traffic to multicast group FF1E::1. The client is a member
of the multicast group.
The client and the source can communicate with each other and the client can receive multicast traffic
from the source.
Figure 14 Network diagram
Configuration procedure (for the WX6103)
1. Configure WLAN services:
# Configure WLAN-ESS interface 1 and assign it to VLAN 100.
<AC>system-view
[AC]Vlan 100
[AC-vlan100]quit
[AC]interface WLAN-ESS 1
[AC-WLAN-ESS1]port access vlan 100
[AC-WLAN-ESS1]quit
# Configure a WLAN service template with its SSID as multicast and authentication method as
open-system. Bind the WLAN-ESS interface with the service template.
[AC]wlan service-template 1 clear
[AC-wlan-st-1]ssid Multicast
[AC-wlan-st-1]bind WLAN-ESS 1
[AC-wlan-st-1]authentication-method open-system
[AC-wlan-st-1]service-template enable
[AC-wlan-st-1]quit
# Create AP template ap of model WA2100 and configure its serial ID as
210235A29G007C00001 on the AC (WX6103 main control board).
[AC]wlan ap ap model WA2100
[AC-wlan-ap-ap]serial-id 210235A29G007C00001
# Configure the type of radio 1 of the AP as 802.11g and map the service template to the current
radio.
[AC-wlan-ap-ap]radio 1 type dot11g
[AC-wlan-ap-ap-radio-1]service-template 1
Router A
Source
AC
GE 0/0/1 GE 0/0/2
IPv6 Multicast Packets
AP
Client
Switch
WLAN-ESS1