Mld snooping proxying configuration example, Network requirements, Configuration procedure – H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 80
71
MLD snooping proxying configuration example
Network requirements
As shown in
, Router A connects to an IPv6 multicast source through port Ethernet 1/2, and to
AC through port Ethernet 1/1. Router A runs MLDv1 and AC runs MLDv1 snooping. Router A serves as
an MLD querier.
Configure MLD snooping proxying on AC so that AC can forward MLD reports and done messages on
behalf of attached hosts, respond to MLD queries from Router A, and forward the queries to the hosts on
behalf of Router A.
Figure 16 Network diagram
Configuration procedure
1.
Configure an IP address and subnet mask for each interface as per
2.
On Router A, enable IP multicast routing, enable MLD on Ethernet 1/1, and enable IPv6 PIM-DM
on each interface.
<RouterA> system-view
[RouterA] multicast ipv6 routing-enable
[RouterA] interface ethernet 1/1
[RouterA-Ethernet1/1] mld enable
[RouterA-Ethernet1/1] pim ipv6 dm
[RouterA-Ethernet1/1] quit
[RouterA] interface ethernet 1/2
[RouterA-Ethernet1/2] pim ipv6 dm
[RouterA-Ethernet1/2] quit
3.
Configure AC:
NOTE:
Ethernet interface configuration may vary with device models. For detailed information about Ethernet
interface configuration of different device models, see "Configure the wireless client to join the multicast
group" in the above configuration examples.
# Enable MLD snooping globally.