H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 74
65
[AC-wlan-ap-ap-radio-1]radio enable
[AC-wlan-ap-ap-radio-1]quit
[AC-wlan-ap-ap]quit
# Enable all radios.
[AC]wlan radio enable all
2.
Configure the wireless client to join the IPv6 multicast group:
# Create VLAN 100 and enable MLD snooping in the VLAN.
<AC>system-view
[AC] mld-snooping
[AC-mld-snooping]quit
[AC]vlan 100
[AC-vlan100] mld-snooping enable
[AC-vlan100]quit
# Configure Ten-GigabitEthernet 2/0/1 as a hybrid interface, and assign it to VLAN 100.
[AC]interface Ten-GigabitEthernet 2/0/1
[AC-Ten-GigabitEthernet2/0/1]port link-type hybrid
[AC-Ten-GigabitEthernet2/0/1]port hybrid vlan 100 tagged
[AC-Ten-GigabitEthernet2/0/1]quit
# Log in to the configuration interface of the switching interface board of the WX6103 and enable
MLD snooping globally.
<AC> oap connect slot 0
Press CTRL+K to quit.
Connected to OAP!
User interface aux0 is available.
Press ENTER to get started.
<Device> system-view
[Device] mld-snooping
# Create VLAN 100, and enable MLD snooping in the VLAN. Configure GigabitEthernet 0/0/2
as a trunk port and assign it to VLAN 100,
[Device] vlan 100
[Device-vlan100] mld-snooping enable
[Device-vlan100] quit
[Device] interface GigabitEthernet 0/0/2
[Device-GigabitEthernet0/0/2] port link-type trunk
[Device-GigabitEthernet0/0/2] port trunk permit vlan 100
[Device-GigabitEthernet0/0/2] quit
# Configure Ten-GigabitEthernet 0/0/1 on the OAP card as a hybrid interface, and assign it to
VLAN 100.
[Device] interface Ten-GigabitEthernet 0/0/1
[Device-Ten-GigabitEthernet0/0/1] port link-type hybrid
[Device-Ten-GigabitEthernet0/0/1] port hybrid vlan 100 tagged
[Device-Ten-GigabitEthernet0/0/1] quit
# Use the shortcut keys Ctrl + K to exit the configuration interface of the switching interface board
and return to the AC configuration interface.
# Configure the client to access the WLAN service and request multicast traffic destined for
FF1E::1.