Mld snooping configuration examples, Network requirements – H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 68
59
MLD snooping configuration examples
IMPORTANT:
to see where you configure Ethernet interfaces.
Table 4 Ethernet interface configuration
Hardware
Ethernet interface configuration prerequisites
Access controller modules (installed in a switch)
LSQM1WCMB0
LSQM1WCMD0
LSBM1WCM2A0
LSRM1WCM2A1
LSRM1WCM3A1
You configure Ethernet interfaces on the switch.
NOTE:
To log in to the access controller module from the switch, use the oap connect
slot
slot-number
command.
LSWM1WCM10
LSWM1WCM20
You configure Ethernet interfaces on the switch.
NOTE:
To log in to the access controller module from the switch, use the oap connect
slot 1
slot-number
system
system-name
command.
Wireless switches
WX3024E
You configure the Ethernet interfaces on the switching engine.
NOTE:
To log in to the switching engine, use the oap connect slot 0 command on
the access controller engine.
Access controllers
WX6103
You configure Ethernet interfaces on the switching interface board.
NOTE:
To log in to the switching interface board, use the oap connect slot 0
command on the active main control board.
WX5002
WX5004
You configure GE interfaces on the access controller.
Multicast delivery to a wireless client (for the WX5000 series)
Network requirements
As shown in
, the source sends multicast traffic to multicast group FF1E::1. The client is a member
of the multicast group.
The client and the source can communicate with each other and the client can receive multicast traffic
from the source.