Igmp snooping proxying configuration example, Network requirements, Configuration procedure – H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 43
34
MAC group(s):
MAC group address:0100-5e01-0101
Host port(s):total 1 port(s).
WLAN-DBSS1:0
The output shows that WLAN-DBSS 1:0 joins the multicast group 224.1.1.1.
IGMP snooping proxying configuration example
Network requirements
As shown in
, Router A connects to a multicast source through port Ethernet 1/2, and to AC
through port Ethernet 1/1. Router A runs IGMPv2 and AC runs IGMPv2 snooping. Router A serves as an
IGMP querier.
Configure IGMP snooping proxying on AC so that AC can forward IGMP reports and leave messages on
behalf of attached hosts, respond to IGMP queries from Router A, and forward the queries to the hosts on
behalf of Router A.
Figure 8 Network diagram
Configuration procedure
1.
Configure an IP address and subnet mask for each interface as per
2.
On Router A, enable IP multicast routing, enable IGMP on Ethernet 1/1, and enable PIM-DM on
each interface.
<RouterA> system-view
[RouterA] multicast routing-enable
[RouterA] interface ethernet 1/1
[RouterA-Ethernet1/1] igmp enable
[RouterA-Ethernet1/1] pim dm
[RouterA-Ethernet1/1] quit
[RouterA] interface ethernet 1/2
[RouterA-Ethernet1/2] pim dm
[RouterA-Ethernet1/2] quit
3.
Configure AC: