H3C Technologies H3C SecPath F1000-E User Manual
Page 142
46
Configure OSPF on the devices in the PIM-SM domain to ensure network-layer reachability among them.
Detailed configuration steps are omitted here.
Step2
Enable IP multicast routing and administrative scoping, and enable PIM-SM and IGMP
# Enable IP multicast routing and administrative scoping on Device A, enable PIM-SM on each interface,
and enable IGMP on the host-side interface GigabitEthernet 1/1.
<DeviceA> system-view
[DeviceA] multicast routing-enable
[DeviceA] pim
[DeviceA-pim] c-bsr admin-scope
[DeviceA-pim] quit
[DeviceA] interface gigabitethernet 1/1
[DeviceA-GigabitEthernet1/1] igmp enable
[DeviceA-GigabitEthernet1/1] pim sm
[DeviceA-GigabitEthernet1/1] quit
[DeviceA] interface gigabitethernet 2/1
[DeviceA-GigabitEthernet2/1] pim sm
[DeviceA-GigabitEthernet2/1] quit
The configuration on Device E and Device I is similar to the configuration on Device A.
# On Device B, enable IP multicast routing and administrative scoping, and enable PIM-SM on each
interface.
<DeviceB> system-view
[DeviceB] multicast routing-enable
[DeviceB] pim
[DeviceB-pim] c-bsr admin-scope
[DeviceB-pim] quit
[DeviceB] interface gigabitethernet 1/1
[DeviceB-GigabitEthernet1/1] pim sm
[DeviceB-GigabitEthernet1/1] quit
[DeviceB] interface gigabitethernet 2/1
[DeviceB-GigabitEthernet2/1] pim sm
[DeviceB-GigabitEthernet2/1] quit
[DeviceB] interface gigabitethernet 3/1
[DeviceB-GigabitEthernet3/1] pim sm
[DeviceB-GigabitEthernet3/1] quit
[DeviceB] interface gigabitethernet 3/2
[DeviceB-GigabitEthernet3/2] pim sm
[DeviceB-GigabitEthernet3/2] quit
The configuration on Device C, Device D, Device F, Device G, and Device H is similar to the configuration
on Device B. The specific configuration steps are omitted here.
Step3
Configure an admin-scope zone boundary
# On Device B, configure GigabitEthernet 3/1 and GigabitEthernet 3/2 as the boundary of
admin-scope zone 1.
[DeviceB] interface gigabitethernet 3/1
[DeviceB-GigabitEthernet3/1] multicast boundary 239.0.0.0 8
[DeviceB-GigabitEthernet3/1] quit
[DeviceB] interface gigabitethernet 3/2