H3C Technologies H3C SecPath F1000-E - Manual (Page 90)

29
Figure 8 Network diagram for SA message filtering configuration
Loop0
Device Interface IP address Device Interface IP address
Source 1 — 10.110.3.100/24 Device C GE1/1 10.110.4.1/24
Source 2 — 10.110.6.100/24 GE2/1 10.110.5.1/24
Device A GE1/1 10.110.1.1/24 GE3/1 192.168.1.2/24
GE2/1 10.110.2.1/24 GE3/2 192.168.2.2/24
GE3/1 192.168.1.1/24 Loop0 2.2.2.2/32
Loop0 1.1.1.1/32 Device D GE1/1 10.110.6.1/24
Device B GE1/1 10.110.3.1/24 GE1/2 10.110.7.1/24
GE2/1 10.110.2.2/24 GE2/1 10.110.5.2/24
GE3/1 192.168.2.1/24 Loop0 3.3.3.3/32
Configuration Procedure
Step1 Configure IP addresses and unicast routing
Configure the IP address and subnet mask for each interface as per Figure 8 . The detailed configuration
steps are omitted here.
Configure OSPF for interoperation among the devices. Ensure the network-layer interoperation within
and between the PIM-SM domains and ensure dynamic update of routing information among the devices
by leveraging unicast routing. The detailed configuration steps are omitted here.
Step2 Enable IP multicast routing, PIM-SM and IGMP, and configure a PIM domain border
# On Device A, enable IP multicast routing, enable PIM-SM on each interface, and enable IGMP on the
host-side interface, GigabitEthernet 1/1.
<DeviceA> system-view
[DeviceA] multicast routing-enable
[DeviceA] interface gigabitethernet1/1
[DeviceA-GigabitEthernet1/1] igmp enable
[DeviceA-GigabitEthernet1/1] pim sm