H3C Technologies H3C SecPath F1000-E User Manual
Page 221
58
[DeviceA-GigabitEthernet1/1] pim ipv6 sm
[DeviceA-GigabitEthernet1/1] quit
[DeviceA] interface gigabitethernet 2/0
[DeviceA-GigabitEthernet2/0] pim ipv6 sm
[DeviceA-GigabitEthernet2/0] quit
[DeviceA] interface gigabitethernet 3/0
[DeviceA-GigabitEthernet3/0] pim ipv6 sm
[DeviceA-GigabitEthernet3/0] quit
The configuration on Device B and Device C is similar to that on Device A. The configuration on Device
D and Device E is also similar to that on Device A except that it is not necessary to enable MLD on the
corresponding interfaces on these two devices.
Step3
Configure the IPv6 SSM group range
# Configure the IPv6 SSM group range to be FF3E::/64 on Device A.
[DeviceA] acl ipv6 number 2000
[DeviceA-acl6-basic-2000] rule permit source ff3e:: 64
[DeviceA-acl6-basic-2000] quit
[DeviceA] pim ipv6
[DeviceA-pim6] ssm-policy 2000
[DeviceA-pim6] quit
The configuration on Device B, Device C, Device D and Device E is similar to that on Device A.
Step4
Verify the configuration
Use the display pim ipv6 interface command to view the IPv6 PIM configuration and running status
on each interface. For example:
# Verify the IPv6 PIM configuration information on Device A.
[DeviceA] display pim ipv6 interface
Interface NbrCnt HelloInt DR-Pri DR-Address
GE1/1 0 30 1 1001::1
(local)
GE2/0 1 30 1 1002::2
GE3/0 1 30 1 1003::2
Assume that Host A needs to receive the information a specific IPv6 multicast source S (4001::100/64)
sends to multicast group G (FF3E::101). Device A builds an SPT toward the multicast source. Devices on
the SPT path (Device A and Device D) have generated an (S, G) entry, while Device E, which is not on
the SPT path, does not have multicast routing entries. You can use the display pim ipv6
routing-table command to view the PIM routing table information on each device. For example:
# View the IPv6 PIM multicast routing table information on Device A.
[DeviceA] display pim ipv6 routing-table
Total 0 (*, G) entry; 1 (S, G) entry
(4001::100, FF3E::101)
Protocol: pim-ssm, Flag:
UpTime: 00:00:11
Upstream interface: GigabitEthernet2/0
Upstream neighbor: 1002::2
RPF prime neighbor: 1002::2