H3C Technologies H3C SecPath F1000-E - Manual (Page 56)

22
[DeviceD-GigabitEthernet1/1] quit
[DeviceD] interface gigabitethernet 1/2
[DeviceD-GigabitEthernet1/2] pim sm
[DeviceD-GigabitEthernet1/2] quit
[DeviceD] interface gigabitethernet 1/3
[DeviceD-GigabitEthernet1/3] pim sm
[DeviceD-GigabitEthernet1/3] quit
# Enable IP multicast routing on Device A, and enable PIM-SM on each interface.
<DeviceA> system-view
[DeviceA] multicast routing-enable
[DeviceA] interface gigabitethernet 1/1
[DeviceA-GigabitEthernet1/1] pim sm
[DeviceA-GigabitEthernet1/1] quit
[DeviceA] interface gigabitethernet 1/2
[DeviceA-GigabitEthernet1/2] pim sm
[DeviceA-GigabitEthernet1/2] quit
[DeviceA] interface gigabitethernet 1/3
[DeviceA-GigabitEthernet1/3] pim sm
[DeviceA-GigabitEthernet1/3] quit
The configuration on Device B and Device C is similar to that on Device A.
Step3 8Configure a C-BSR and a C-RP
# Configure C-BSR and C-RP interfaces on Device D.
[DeviceD] pim
[DeviceD-pim] c-bsr gigabitethernet 1/3
[DeviceD-pim] c-rp gigabitethernet 1/3
[DeviceD-pim] quit
Step4 Configure the SSM group range
# Configure the SSM group range 232.1.1.0/24 on Device D.
[DeviceD] acl number 2000
[DeviceD-acl-basic-2000] rule permit source 232.1.1.0 0.0.0.255
[DeviceD-acl-basic-2000] quit
[DeviceD] pim
[DeviceD-pim] ssm-policy 2000
[DeviceD-pim] quit
The configuration on Device A, Device B and Device C is similar to that on Device D.
Step5 Configure IGMP SSM mappings
# Configure IGMP SSM mappings on Device D.
[DeviceD] igmp
[DeviceD-igmp] ssm-mapping 232.1.1.0 24 133.133.1.1
[DeviceD-igmp] ssm-mapping 232.1.1.0 24 133.133.3.1
[DeviceD-igmp] quit
Step6 Verify the configuration
Use the display igmp ssm-mapping command to view the IGMP SSM mappings on the device.