H3C Technologies H3C SecPath F1000-E - Manual (Page 191)

28
To do... Use the command... Remarks
Enter system view system-view —
Enable IPv6 multicast routing
multicast ipv6
routing-enable Required
Disable by default
Enter interface view
interface interface-type
interface-number
—
Enable IPv6 PIM-SM pim ipv6 sm
Required
Disabled by default
CAUTION:
All the interfaces of the same device must work in the same IPv6 PIM mode.
NOTE:
For more information about the multicast ipv6 routing-enable command, see IPv6 Multicast Routing and
Forwarding Commands in the IP Multicast Volume.
Configuring the IPv6 SSM Group Range
As for whether the information from an IPv6 multicast source is delivered to the receivers based on the
IPv6 PIM-SSM model or the IPv6 PIM-SM model, this depends on whether the group address in the (S, G)
channel subscribed by the receivers falls in the IPv6 SSM group range. All IPv6 PIM-SM-enabled
interfaces assume that IPv6 multicast groups within this address range are using the IPv6 SSM model.
Perform the following configuration on all routers in the IPv6 PIM-SM domain.
Follow these steps to configure the IPv6 SSM group range:
To do... Use the command... Remarks
Enter system view system-view —
Enter IPv6 PIM view pim ipv6 —
Configure the IPv6 SSM group
range
ssm-policy acl6-number
Optional
FF3x::/32 by default, here “x”
refers to any legal group scope.
CAUTION:
•
Make sure that the same IPv6 SSM group range is configured on all routers in the entire domain.
Otherwise, IPv6 multicast data cannot be delivered through the IPv6 SSM model.
• When a member of an IPv6 multicast group in the IPv6 SSM group range sends an MLDv1 report
message, the device does not trigger a (*, G) join.
Configuring IPv6 PIM Common Features