H3C Technologies H3C SecPath F1000-E - Manual (Page 55)

21
• Source 1, Source 2, and Source 3 send multicast packets to multicast groups in the SSM group
range. It is required to configure the IGMP SSM mapping feature on Device D so that the receiver
host will receive multicast data from Source 1 and Source 3 only.
Network diagram
Figure 6 Network diagram for IGMP SSM mapping configuration
Device Interface IP address Device Interface IP address
Source 1 — 133.133.1.1/24 Source 3 — 133.133.3.1/24
Source 2 — 133.133.2.1/24 Receiver — 133.133.4.1/24
Device A GE1/1 133.133.1.2/24 Device C GE1/1 133.133.3.2/24
GE1/2 192.168.1.1/24 GE1/2 192.168.3.1/24
GE1/3 192.168.4.2/24 GE1/3 192.168.2.2/24
Device A GE1/1 133.133.2.2/24 Device D GE1/1 133.133.4.2/24
GE1/2 192.168.1.2/24 GE1/2 192.168.3.2/24
GE1/3 192.168.2.1/24 GE1/3 192.168.4.1/24
Configuration procedure
Step1 Configure IP addresses and unicast routing
Configure the IP address and subnet mask of each interface as per Figure 6 . The detailed configuration
steps are omitted here.
Configure OSPF for interoperability among the devices. Ensure the network-layer interoperation in the
PIM-SM domain and dynamic update of routing information among the devices through a unicast routing
protocol. The detailed configuration steps are omitted here.
Step2 Enable IP multicast routing, enable PIM-SM on each interface, and enable IGMP and IGMP SSM
mapping on the host-side interface.
# Enable IP multicast routing on Device D, enable PIM-SM on each interface and enable IGMPv3 and
IGMP SSM mapping on GigabitEthernet 1/1.
<DeviceD> system-view
[DeviceD] multicast routing-enable
[DeviceD] interface gigabitethernet 1/1
[DeviceD-GigabitEthernet1/1] igmp enable
[DeviceD-GigabitEthernet1/1] igmp version 3
[DeviceD-GigabitEthernet1/1] igmp ssm-mapping enable
[DeviceD-GigabitEthernet1/1] pim sm