H3C Technologies H3C SecPath F1000-E - Manual (Page 190)

27
To do... Use the command... Remarks
Enter system view system-view —
Enter IPv6 PIM view pim ipv6 —
Configure the SPT switchover
spt-switch-threshold infinity
[ group-policy acl6-number
[ order order-value ] ]
Optional
By default, the device switches to
the SPT immediately after it
receives the first IPv6 multicast
packet from the RPT.
Configuring IPv6 PIM-SSM
NOTE:
The IPv6 PIM-SSM model needs the support of MLDv2. Therefore, be sure to enable MLDv2 on IPv6 PIM
routers with receivers attached to them.
IPv6 PIM-SSM Configuration Task List
Complete these tasks to configure IPv6 PIM-SSM:
Task Remarks
Enabling IPv6 PIM-SM Required
Configuring the IPv6 SSM Group Range Optional
Configuring IPv6 PIM Common Features Optional
Configuration Prerequisites
Before configuring IPv6 PIM-SSM, complete the following task:
• Configure any IPv6 unicast routing protocol so that all devices in the domain are interoperable at
the network layer.
Before configuring IPv6 PIM-SSM, prepare the following data:
• The IPv6 SSM group range
Enabling IPv6 PIM-SM
The SSM model is implemented based on some subsets of IPv6 PIM-SM. Therefore, a router is IPv6
PIM-SSM capable after you enable IPv6 PIM-SM on it.
When deploying an IPv6 PIM-SM domain, you are recommended to enable IPv6 PIM-SM on all
non-border interfaces of routers.
Follow these steps to enable IPv6 PIM-SSM: