Epson EcoTank ET-4550 - Manual (Page 69)

Note:
❏ If there are any errors reported, follow the instructions on the report to solve them.
❏ If you are prompted to select the line type, select the line type. When you are connecting the printer to a PBX phone
system or terminal adapter, select PBX.
❏ If the screen indicates that the dial tone is not detected, press the u button to disable the dial tone detection feature.
However, disabling the dial tone detection feature may cause the printer to skip the first digit of a fax number when
dialing and send the fax to the wrong number.
11. When Start is displayed again, press the d button. Select Done to quit the wizard.
Related Information
& “Connecting the Printer to a Phone Line” on page 64
& “Setting Receiving Mode” on page 74
& “Making Settings for a PBX Phone System” on page 69
& “Fax Settings” on page 22
Making Basic Fax Settings Individually
You can make fax settings without using the fax setting wizard by selecting each setting menu individually. The
settings configured using the wizard can also be changed. For more details, see the list of menus in fax settings.
Related Information
& “Fax Settings” on page 22
Making Settings for a PBX Phone System
Make the following settings when using the printer in offices that use extensions and require external access codes,
such as 0 and 9, to get an outside line.
1. Enter Setup from the home screen.
2. Select Fax Settings > Basic Settings > Line Type.
3. Select PBX.
4. Select Use as the access code.
5. On the Access Code screen, enter the external access code used for your phone system, and then press the OK
button.
The access code is stored in the printer. When sending a fax to an outside fax number, enter # (hash) instead of
the actual access code.
Note:
When # (hash) is entered at the beginning of the fax number, the printer replaces the # with the stored access code when
dialing. Using # helps avoid connection problems when connecting to an outside line.
User's Guide
Faxing
69