Canon EOS R6 Mark II Mirrorless Camera with 24-105mm f/4-7.1 Lens User Manual

Page 1015

Advertising
background image

The charger's lamp does not blink.

For safety, hot or cold batteries inserted in the charger are not charged, and the lamp
remains off. In this case, let the battery adjust to the ambient temperature before
attempting to charge it again. During charging, if the battery's temperature becomes
high for any reason, charging will stop automatically (lamp blinks). When the battery
temperature goes down, charging will resume automatically.

Batteries cannot be charged with the USB power adapter (sold
separately).

Batteries are not charged while the camera power switch is set to <

>. However,

batteries are charged during auto power off.
Battery Pack LP-E6 cannot be charged.
Batteries are not charged when their remaining capacity is already approx. 94% or
higher.
Operating the camera will stop charging in progress.

The access lamp blinks during charging with the USB power adapter.

In case of charging problems, the access lamp blinks in green and a protective circuit
stops charging. In this case, unplug the power cord, reattach the battery, and wait a few
minutes before plugging it in again. If the problem persists, take the camera to the
nearest Canon Service Center.
If batteries are hot or cold, the access lamp blinks in green and a protective circuit stops
charging. In this case, let the battery adjust to the ambient temperature before
attempting to charge it again.

The access lamp is not lit during charging with the USB power adapter.

Try unplugging the USB power adapter and plugging it in again.

The camera cannot be powered with the USB power adapter.

Check the battery compartment. The camera cannot be powered without a battery pack.
Check the remaining battery level. When batteries are depleted, the adapter charges
them. In this case, power is not supplied to the camera.

The camera is not activated even when the power switch is set to
<

>.

Make sure the battery is inserted properly in the camera (

).

Make sure the card slot cover is closed (

).

Charge the battery (

).

1015

Advertising