FUJITSU MB91460 SERIES FR60 - Manual (Page 911)

895
Chapter 44 A/D Converter
3.Registers of A/D Converter
• ADECH (ADC0): Address 01ABh (Access: Word, Half-word, Byte )
(See “ Meaning of Bit Attribute Symbols (Page No.10) ” for details of the attributes.)
These bits set the start and end channel for A/D converter.
Setting of ANE4 to ANE0 the same channel as in ANS4 to ANS0 specifies conversion for that channel
only. (Single conversion)
In continuous or stop mode, conversion is performed up to the channel specified by ANE4 to ANE0.
Conversion then starts again from the start channel specified by ANS4 to ANS0.
If ANS > ANE, conversion starts with the channel specified by ANS, continuous up to channel 31, starts
again from channel 0, and ends with the channel specified by ANE.
Initialized to ANS="00000", ANE="00000" by a reset.
ex. Channel Setting ANS=30ch, ANE=3ch, single conversion mode
Operation : Conversion channel 30ch -> 31ch -> 0ch -> 1ch -> 2ch -> 3ch end
[bit 12 to 8] ANS4-0 (Analog start channel set)
[bit 4 to 0] ANE4-0 (Analog end channel set)
7 6 5 4 3 2 1 0 Bit
- - - ANE4 ANE3 ANE2 ANE1 ANE0
- - - 0 0 0 0 0
Initial
value
RX, W0 RX, W0 RX, W0 R/W R/W R/W R/W R/W Attribute
ANS4
ANE4 ANS3
ANE3 ANS2
ANE2 ANS1
ANE1 ANS0
ANE0
Start / End Channel
0 0 0 0 0 AN0
0 0 0 0 1 AN1
0 0 0 1 0 AN2
0 0 0 1 1 AN3
0 0 1 0 0 AN4
0 0 1 0 1 AN5
0 0 1 1 0 AN6
0 0 1 1 1 AN7
0 1 0 0 0 AN8
0 1 0 0 1 AN9
0 1 0 1 0 AN10
0 1 0 1 1 AN11
0 1 1 0 0 AN12
0 1 1 0 1 AN13
0 1 1 1 0 AN14
0 1 1 1 1 AN15
1 0 0 0 0 AN16
1 0 0 0 1 AN17
1 0 0 1 0 AN18
1 0 0 1 1 AN19
1 0 1 0 0 AN20
1 0 1 0 1 AN21
1 0 1 1 0 AN22
1 0 1 1 1 AN23
1 1 0 0 0 AN24
1 1 0 0 1 AN25
1 1 0 1 0 AN26
1 1 0 1 1 AN27
1 1 1 0 0 AN28
1 1 1 0 1 AN29
1 1 1 1 0 AN30
1 1 1 1 1 AN31