Genicom microLaser 170 - Manual (Page 101)

Specifications
88 Zebra XiII Printer User’s Guide
Printer Fonts
Standard Printer Fonts
For more information on fonts, refer to the ZPL II Programming Guide.
• Bit-mapped fonts A, B, C, D, E, F, G, H, and GS are expandable up to 10
times, height- and width-independent. However, fonts E and H (OCR-B
and OCR-A) are not considered in-spec when expanded.
• The scalable (smooth) font (CG Triumvirate™ Bold Condensed) is
expandable on a dot-by-dot basis, height- and width-independent, while
maintaining smooth edges, to a maximum of 1500
´ 1500 dots.
• IBM Code Page 850 international characters are available in fonts A, B,
C, D, E, F, G, and Ø through software control.
Table 7. Eight Dots/mm Printhead
Standard Dot Matrix Type Minimum Character Size
Fonts Height ´
Width (in dots)
Inter-
charac-
ter Gap
U = Uppercase
L = Lowercase
D = Descenders
Height ´ Width Character Density
A 9 ´ 5 1 U-L-D
0.044” ´ 0.029”
1.13 mm ´ 0.75 mm
33.90 Char./inch
1.33 Char./mm
B 11 ´ 7 2 U
0.054” ´ 0.044”
1.38 mm ´ 1.13 mm
22.60 Char./inch
0.89 Char./mm
C, D 18 ´ 10 2 U-L-D
0.088” ´ 0.059”
2.25 mm ´ 1.50 mm
16.95 Char./inch
0.67 Char./mm
E 28 ´ 15 5 OCR-B
0.138” ´ 0.098”
3.50 mm ´ 2.50 mm
10.17 Char./inch
0.40 Char./mm
F 26 ´ 13 3 U-L-D
0.128” ´ 0.079”
3.25 mm ´ 2.00 mm
12.71 Char./inch
0.50 Char./mm
G 60 ´ 40 8 U-L-D
0.295” ´ 0.236”
7.50 mm ´ 6.00 mm
4.24 Char./inch
0.17 Char./mm
H 21 ´ 13 6 OCR-A
0.103” ´ 0.093”
2.63 mm ´ 2.38 mm
10.71 Char./inch
0.42 Char./mm
GS 24 ´ 24 0 SYMBOL
0.118” ´ 0.118”
3.00 mm ´ 3.00 mm
8.48 Char./inch
0.33 Char./mm
Ø Default: 15 ´ 12 U-L-D Scalable (smooth) font
xi2ch6 Page 88 Tuesday, April 23, 1996 12:41 PM