Genicom microLaser 170 - Manual (Page 89)

Options
76 Zebra XiII Printer User’s Guide
Cutter
Your Zebra XiII printer may be equipped with a cutter used to cut the labels
after they are printed. The Cutter Option may be installed concurrently with
other options including the Rewind Option. The Cutter Option may be fac-
tory-installed or it may be installed in the field by a qualified service techni-
cian.
The Cutter Option must be enabled by entering the Programming Mode and
using the front panel display to select the Cutter Print Mode. See Chapter 2,
“Operation,” for additional information. The Cutter Catch Tray may be
installed to collect labels, tickets, or tags after being cut.
Internal Fanfold Media Supply Bin
Your Zebra XiII-Series printer may be equipped with an optional internal
Fanfold Media Supply Bin. It is used to load fanfold media within the XiII
printer’s media compartment, and protects the media from environmental
contaminants such as dust and dirt. The Fanfold Media Supply Bin may be
installed in the field by the operator.
Note: The Fanfold Media Supply Bin may not be installed in XiII printers with the
Rewind Option. Fanfold media may be used on printers with the Rewind
Option installed by using one of the external fanfold supply access slots at
the bottom and rear of the printer.
Memory SIMMs
Memory SIMMs increase the graphics storage capacity of the printer,
increase the maximum print length, and/or increase through-put by increas-
ing format-while-print abilities. Contact your sales representative to pur-
chase compatible SIMMs in 1, 2, 4, and 8 MB sizes.
xi2ch5 Page 76 Tuesday, April 23, 1996 12:36 PM