Genicom microLaser 170 - Manual (Page 34)

Zebra XiII Printer User’s Guide 21
Getting Started
Ribbon Removal
1. Break the ribbon as close to the Ribbon Take-Up Spindle as possible.
2. Refer to Figure 8. Pull the hook out slightly, rotate the hook back-and-
forth several times as shown, and then remove it from the spindle.
3. Grasp the used ribbon and remove it from the Ribbon Take-Up Spindle.
4. Remove the empty core from the Ribbon Supply Spindle.
5. Follow the Ribbon Loading procedure on page 19 to load the new rib-
bon.
Figure 8. Removing Used Ribbon
xi2ch1 Page 21 Tuesday, April 23, 1996 12:22 PM