Genicom microLaser 170 - Manual (Page 58)

Ze
b
ra
Xi
II P
ri
n
te
r U
se
r’s
Gu
id
e
4
5
O
per
ati
o
n
Label Positioning Parameters
B A C K F E E D
Backfeed Sequence Press the right or left oval key to display other choices.
Default: Default (“Default” is defined as 90%)
Selections: Default, after, before, 10%, 20%, 30%, 40%, 50%, 60%, 70%, 80%
This parameter establishes when and how much label backfeed occurs after a label is removed or
cut in the Peel-Off, Cutter, and Applicator modes. It has no effect in Rewind or Tear-Off Modes.
This parameter setting can be superseded by the ~JS instruction when received as part of a label
format. (Refer to the ZPL II Programming Guide.)
Note: The difference between the value entered and 100% establishes how much backfeed
occurs before the next label is printed. For example, a value of 40 means that 40% of the backfeed
takes place after the label is removed or cut. The remaining 60% takes place before the next label is
printed. A value of “before” means that all backfeed will take place before the next label is printed.
L A B E L T O P
Adjusting Label Top Position Press the right oval key to increase the value, press the left oval
key to decrease the value. The displayed value represents dots.
Default: +0 Range: -120 to +120 dot rows
The Label Top Position adjusts the print position vertically on the label. Positive numbers adjust
the label top position further down the label (away from the printhead), negative numbers adjust the
position up the label (toward the printhead).
L E F T P O S I T I O N
Adjusting Left Position Press the left oval key to move to the next position, press the right oval
key to change between + and - and to increase the value of the digit. The displayed value represents
dots.
Default: 0000 Range: -9999 to +9999
Note: For a negative value, enter the value before changing to the minus sign.
This parameter establishes how far from the left edge of a label the format will begin to print by
adjusting horizontal positioning on the label. Positive numbers adjust the printing to the left by the
number of dots selected, negative numbers shift printing to the right.
xi2ch2
Page 4
5
Tuesda
y
, Apr
il
23,
1996
1:
45
PM