Cleaning the exterior, Cleaning the interior, Cleaning the printhead and platen roller – Genicom microLaser 170 User Manual

Page 69

Advertising
background image

Routine Care and Adjustment

56

Zebra XiII Printer User’s Guide

Table 5 on page 55 provides a brief cleaning schedule. Specific cleaning
procedures are provided below. A Preventive Maintenance Kit (part #
01429) is available from Zebra. Kit items are also sold separately by the
part numbers shown.

Preventive Maintenance Kit

Solvent (Alcohol), 4 oz. bottle (part # 01426)

Applicators, bag of 100 (part # 01427)

Cleaning the Exterior

The exterior surfaces of the Zebra XiII-Series printer may be cleaned with a
lint-free cloth. Do not use harsh or abrasive cleaning agents or solvents. If
necessary, a mild detergent solution or desktop cleaner may be used spar-
ingly.

Cleaning the Interior

Remove any accumulated dirt and lint from the interior of the printer using
a soft bristle brush and/or vacuum cleaner. Inspect this area after every four
rolls of media.

Cleaning the Printhead and Platen Roller

Inconsistent print quality, such as voids in the bar code or graphics, may
indicate a dirty printhead. For best results, perform the following cleaning
procedure after every roll of ribbon.

Note:

You do not need to turn the printer off before cleaning the printhead. If
power is turned off, all label formats and images, as well as any temporarily
saved parameter settings stored in the printer's internal memory, will be
lost. When power is turned back on, you will need to reload these items.

To clean the printhead, refer to Figure 11 and follow these steps:

1. Open the Media Compartment Door.

xi2ch3 Page 56 Tuesday, April 23, 1996 12:32 PM

Advertising
This manual is related to the following products: