Genicom microLaser 170 - Manual (Page 32)

Zebra XiII Printer User’s Guide 19
Getting Started
Ribbon Loading
To load ribbon, refer to Figures 6 and 7 and follow the procedure below.
Note: Use ribbon that is at least as wide as the media. The smooth backing of the
ribbon protects the printhead from wear and premature failure due to exces-
sive abrasion.
For Direct Thermal Print Mode, ribbon is not used and should not be loaded
in the printer.
1. Align the segments of the Ribbon Supply Spindle.
Figure 7. Ribbon Loading Diagram for the 170XiII and 220XiII Printers
xi2ch1 Page 19 Tuesday, April 23, 1996 12:22 PM